subject
Engineering, 20.09.2020 15:01 alani64

Radiative cooling can be used to freeze water in the desert at night. Consider a shallow pan of water is placed outdoors at night, well insulated from the ground below. The surface of the water has an emissivity of 0.8. The effective night sky temperature on this clear day is 260 K. Air blows very gently over the pan, creating a convective heat transfer coefficient of 10 W/m2 -K. a. Write an expression for the rate of heat loss from the pan to the sky.
b. Write an expression for the rate of heat gain to the pan from the air.
c. What is the maximum air temperature for which the water will freeze? (Hint: Assume the water temperature is at freezing, and perform a steady state energy balance on the pan).
d. If the pan were not well insulated from the ground, would the maximum air temperature for freezing be higher or lower? Explain your answer (Hint: think about the energy balance on the pan of water).

ansver
Answers: 2

Another question on Engineering

question
Engineering, 03.07.2019 15:10
If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.
Answers: 1
question
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
question
Engineering, 04.07.2019 18:10
Assuming compressible flow of air and that the measurements are done at flagstaff a pitot static tube that gives the difference of total and static pressure measures 0.35 m of mercury. what is the velocity of air? assume the temperature to be 300k. (submit your excel or matlab calculation sheet)
Answers: 1
question
Engineering, 04.07.2019 18:10
Ifa component is made of two or more materials with different modulus of elasticity (e), it is called a composite member and we calculate the factor·n". mention the formula for calculating n". also, ifn> 1, explain what will happen to the 1. transformed.gi) ifn 1, what will happen to the material when transformed material when
Answers: 1
You know the right answer?
Radiative cooling can be used to freeze water in the desert at night. Consider a shallow pan of wate...
Questions
question
Mathematics, 29.01.2020 07:57
question
Mathematics, 29.01.2020 07:57
question
Biology, 29.01.2020 07:57
Questions on the website: 13722367