Engineering, 21.09.2020 04:01 ilovecupcakes8459

A Manufacturing company has a limit of 25 mg/m3 sulfur dioxide (SO2) in emissions from all of the stacks on their campus. To meet this output limit, the plant operator decides to blend the exhaust stream from a coal-fired boiler with the exhaust stream from a boiler using low-sulfur diesel. If the coal-fired boiler exhaust contains 57 mg/m3 SO2 and the diesel-powered boiler contains 1.5 mg/m3, in what ratio do these two exhaust streams need to be blended before they are released from a stack to meet the SO2 limit? You may assume that SO2 is conservative.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Atank with constant volume contains 2.27 kg of a mixture of water phases (liquid-vapor). in the initial state the temperature and the quality are 127 °c and 0.6, respectively. the mixture is heated until the temperature of 160 oc is reached. illustrate the process in a t-v diagram. then, determine (1) the mass of the vapor in kg at the initial state, (2) the final pressure in kpa.

Answers: 3

Answer

Engineering, 04.07.2019 19:10

The short distance from the objective lens to the object causes problems at high magnification. which of the following is the most serious? a. cleaning the object surface b. positioning the object c. reflection from the object surface. d. illumination of the object

Answers: 1

Answer

You know the right answer?

A Manufacturing company has a limit of 25 mg/m3 sulfur dioxide (SO2) in emissions from all of the st...

Questions