Engineering, 21.09.2020 21:01 tylerkrobinson5444

Propionic acid is diffusing through a 4.0 mm stagnant thick film of deuterium oxide (heavy water) at 298 K. At one end of the film, the concentration of propionic acid is 16.8 wt% and the solution density is rho1 = 1072.8 kg/m^3 . At the other end of the film the concentration of propionic acid is 6.8 wt% and rho2 = 1088.1 kg/m^3 . The diffusivity of propionic acid in deuterium oxide is 1.01 x 10^-9 m^2 /s. a. Calculate the steady-state flux Na.
b. Assuming the binary mixture is a dilute solution of propionic acid, calculate the steady-state flux NA.
c. Compare NA from part (a) and (b). What can you conclude about the system from this?

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

The characteristic roots of a dynamic system are: 1.7920 1.8160 i, -1.7920 1.8160 i, -0.4160 what is the order of this system? what are the settling time and damping ratio of the system?

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Refrigerant-134a enters the compressor of a refrigerator as superheated vapor at 0.14 mpa and -10°c at a rate of 0.05 ka/s and leaves at 0.8 mpa and 50°c. the refrigerant is cooied in the condenser to 0.72 mpa and 26'c. it is then throttled to 0.15 mpa. sketch the t-s diagram for the system and evaluate: 6) the rate of heat removai from the refrigerated space (kw), it) the power input to the compressor (kw), ii) the isentropic efficiency of the compressor (%), and iv) the cop of the refrigerator.

Answers: 2

Answer

You know the right answer?

Propionic acid is diffusing through a 4.0 mm stagnant thick film of deuterium oxide (heavy water) at...

Questions