Engineering, 22.09.2020 14:01 cupcake3103670

Your first digital design assignment in your new job is to design a braking system for a driverless car. The system has 3 inputs that your circuit must depend upon: 1) An input signal x=1 will indicate the speed is greater than or equal to 50 mph.
2) An input signal y 1 will indicate that it is raining
3) An input signal z-0 will indicate that the distance to another car in front of your car is less than or equal to 100 ft. Your circuit is to generate a signal, F, to apply the brakes under any one of the following conditions
a. The speed is greater than or equal to 50 mph and the distance to the car ahead is less than or equal to 100 ft.
b. is raining and the distance to the car ahead is less than or equal to 100 ft
c. It is raining and the speed is greater than or equal to 50 mph
A. Write the switching expression for the output, F.
B. Expand F to SOP short form (list minterms) using only a K-Map
C. Write the short-form Product of Sums (maxterms). D] Determine the reduced Product of Sums expression from the K-Map.
E. Draw the simplest implementation for a NAND/NAND circuit.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 03:10

What precautions should you take to prevent injuries when dealing with heavy loads?

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

Answer

Engineering, 04.07.2019 18:10

An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature

Answers: 2

Answer

You know the right answer?

Your first digital design assignment in your new job is to design a braking system for a driverless...

Questions