subject
Engineering, 23.09.2020 14:01 Geo777

We jump ahead to modern times and find Lazydog having lunch at Shoney's. While pounding down a BBQ bacon cheeseburger (only 1470 calories and 49 fat grams), the good professor worked on the following problems. Grab yourself an 875 calorie Ultimate Hot Fudge Cake from Shoney's and help the prestigious professor solve these problems. 1. The honored Lazydog fondly recalls the many times he has sliced a golf ball into the water. This leads him to decide to calculate the terminal velocity in water of a 4.3 cm diameter ball that has a specific gravity of 1.22. Assume the viscosity of water is 1.0x10-3 Pa⋅s. What do you calculate as the terminal velocity of this ball in water?(include units with answer)2. The distinguished Lazydog now decides to calculate how long it would take to drain a 2.8 ft wide by 5.2 ft long bathtub from full to half full. The initial height of the water in the tub is 2.2 ft and the water goes out a 2.3 inch diameter drain in the bottom of the tub.(include units with answer)3. The celebrated Lazydog has recently added a 87 m3 workshop on to his house. What diameter must a 16 m long air duct have if the heating and air conditioning system is to replenish the air in the room every 16 minutes? The pump can exert a change in gage pressure of0.63x10-3 atm. The viscosity of air is 0.018x10-3 Pa⋅s.(include units with answer)

ansver
Answers: 2

Another question on Engineering

question
Engineering, 03.07.2019 14:10
If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.
Answers: 3
question
Engineering, 03.07.2019 15:10
Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.
Answers: 1
question
Engineering, 04.07.2019 18:10
For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater
Answers: 3
question
Engineering, 04.07.2019 18:10
Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux
Answers: 3
You know the right answer?
We jump ahead to modern times and find Lazydog having lunch at Shoney's. While pounding down a BBQ b...
Questions
question
Chemistry, 24.03.2021 07:10
question
Spanish, 24.03.2021 07:10
question
Mathematics, 24.03.2021 07:10
question
Mathematics, 24.03.2021 07:10
question
Mathematics, 24.03.2021 07:10
question
History, 24.03.2021 07:10
Questions on the website: 13722367