Engineering, 04.10.2020 05:01 kyleemarie2003

A car is traveling up a 3% grade, with the speed of 85mph, on a road that has good, wet pavement. The radius of the wheels is 15 inches, the driveline slippage is 3%, and the overall gear reduction ratio is 2.5 to 1. A deer jumps out onto the road and the driver applies the brakes 290-ft from it. The driver hits the deer at a speed of 20mph. If the driver did not have antilock brakes, and the wheels were locked the entire distance, would a deer-impact speed of 20mph be possible? (Hint: check the braking efficiency) [Use Theoretical Stopping Distance] [15 points]

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

The higher the astm grain-size number, the coarser the grain is. a)-true b)-false

Answers: 3

Answer

You know the right answer?

A car is traveling up a 3% grade, with the speed of 85mph, on a road that has good, wet pavement. Th...

Questions