Engineering, 05.10.2020 15:01 sherlock19

After one side of the stock is planed to a true surface, it is usually best to:
a. Plane the stock to width.
b. Cut the stock to required length.
c. Plane one end square.
d. Plane the opposite face.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux

Answers: 3

Answer

Engineering, 04.07.2019 18:20

The characteristic roots of a dynamic system are: 1.7920 1.8160 i, -1.7920 1.8160 i, -0.4160 what is the order of this system? what are the settling time and damping ratio of the system?

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.

Answers: 1

Answer

You know the right answer?

After one side of the stock is planed to a true surface, it is usually best to:
a. Plane the...

Questions

SAT, 16.03.2022 09:40

A group of students used this diagram to classify three organisms into different kingdoms. Which table correctly identifies the three kingdoms?...

SAT, 16.03.2022 09:40

Estimate √50 to the hundredths place. 1. Estimate between two whole numbers: 72 = 49, 82 = 64 2. Estimate further to the tenths place: 7. 02 = 49. 0,...