Engineering, 08.10.2020 14:01 tannerroland

For the following problems for heat conduction in solids, state the 1) differential equation, 2) initial condition and/or boundary conditions, 3) solution method you would use to obtain answers to the questions below State and justify any assumptions that you make at arriving at your conclusions. Note: You do not need to solve the problems
a) A membrane is cured by heating a thin polymer film to a temperature of T1 throughout the entire thickness of the membrane. Curing is accomplished by sandwiching the membrane between two heated plates, which are brought to a temperature of T1 at a given time. You are interested in determining how long it will take to heat the entire thickness of the membrane to the temperature T1
b) A thick ceramic wall of thickness 10 cm is used to prevent heat from being transferred from a flash photolysis reactor to the surrounding room. If the thermal diffusivity of the ceramic is 3 x 10-7 m2ls, answer the following
1. Is the ceramic material sufficient to prevent measurable heat from being transferred to the room, if the flash photolysis reactor is operated for 1 s?
2. Is the ceramic material sufficient to prevent measurable heat from being transferred to the room, if the flash photolysis reactor is operated for 100 s?
3. What is the heat flux into the room if the flash photolysis reactor is operated continuously for several days?

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.

Answers: 3

Answer

Engineering, 06.07.2019 03:10

Two slings are used to lift a girder of length l and uniform weight per unit length. what is the best position for the slings if the bending moment due to the weight of the girder is to be kept to a minimum?

Answers: 2

Answer

You know the right answer?

For the following problems for heat conduction in solids, state the 1) differential equation, 2) in...

Questions