Engineering, 13.10.2020 03:01 querline87

Uniform internal heat generation at q˙⁢ = 5.00 × 107 W/m3 is occurring in a cylindrical nuclear reactor fuel rod of 43-mm diameter, and under steady-state conditions the temperature distribution is of the form T(r)=a+br2 , where T is in degrees Celsius and r is in meters, while a= 800 °C and b= -4.167 × 105 °C/m2. The fuel rod properties are k= 30 W/m·K, rho= 1100 kg/m3, and cp= 800 J/kg·K. What is the rate of heat transfer per unit length of the rod at r = 0 (the centerline) and at r = 25 mm (the surface)? If the reactor power level is suddenly increased to q2 = 108 W/m3, what is the initial time rate of temperature change at r = 0 and r = 25 mm?

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 19:30

When using the ohmmeter function of a digital multimeter, the leads are placed in what position relative to the component being tested? a. parallel b. control c. series d. line

Answers: 3

Answer

Engineering, 04.07.2019 18:10

An air compression refrigeration system is to have an air pressure of 100 psia in the brine tank and an allowable air temperature increase of 60°f for standard vapor compression cycle temperatures of 77 f entering the expansion cylinder and 14 f entering the compression cylinder, calculate the coefficient of performance a. 2.5 b 3.3 c. 4.0 d. 5.0

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Ahelical coil spring has a mean diameter of 50 mm, a wire diameter of 5.5 mm and is wound with a pitch of 10 mm. the spring steel has an ultimate strength of 1250 mpa. find the force needed to compress the spring solid and the wire stress in this condition. state whether the spring will return to its initial length.

Answers: 1

Answer

Engineering, 04.07.2019 19:20

Apiping systems consists of 6 m of 6-std type k and 12 m of 4-std type k, both drawn copper tubing. the system conveys ethylene glycol at a rate of 0.013 m3/s. the pressure drop across the system is to be calculated. there are two 90° elbows in the 6-in pipe, a reduction from the 6-in pipe to the 4-in pipe and four 90° elbows in the 4-in pipe. all fittings are soldered (same as flanged) and regular. the inlet and outlet of the system are at the same height.

Answers: 1

Answer

You know the right answer?

Uniform internal heat generation at q˙⁢ = 5.00 × 107 W/m3 is occurring in a cylindrical nuclear reac...

Questions