Engineering, 16.10.2020 07:01 ldpozorski

State whether the following statements are true or false. Provide a brief justification for your answer. a. Consider a SDOF system with Coulomb damping. When displaced from the equilibrium position and released, the mass may not move at all.
b. Consider a SDOF system with an ideal viscous damper. When displaced from the equilibrium position and released, the mass will always undergo oscillatory motion.
c. The damped natural frequency of a system is always greater than the undamped natural frequency
d. For an undamped system undergoing a harmonic forcing, the amplitude of the response approaches zero as the forcing frequency becomes very high.
e. The amplitude of free response of SDOF system with Coulomb damping decreases

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

True or false (explain) (110)[111] is a slip system in bcc metals . the {111} family in fcc contains 8 planes. resolved shear stress (rss) in single crystals is just related to the applied stress. critical resolved shear stress (crss) in single crystal metals is direct proportional to the number of defects in the structure

Answers: 2

Answer

You know the right answer?

State whether the following statements are true or false. Provide a brief justification for your ans...

Questions