Engineering, 16.10.2020 14:01 bigboy43

A horizontal structure consists of an 10-mm-thick layer of copper and an 10-mm-thick layer of aluminum. The bottom surface of the composite structure receives a heat flux of 100 kW/m^2, while the top surface is exposed to convective conditions characterized by h= 40 W/m^2·K, T[infinity] =25°C. The initial temperature of both materials is Ti, A = Ti, B=25°C, and a contact resistance of 200 × 10^−6 m^2·K/W exists at the interface between the two materials. Required:
a. Determine the times, both in seconds, at which the copper and aluminum each reach a temperature of 90°C. The copper layer is on the bottom.
b. Repeat part (a) with the copper layer on the top.

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Amass of 1.5 kg of air at 120 kpa and 24°c is contained in a gas-tight, frictionless piston-cylinder device. the air is now compressed to a final pressure of 720 kpa. during the process, heat is transferred from the air such that the temperature inside the cylinder remains constant. calculate the boundary work input during this process.

Answers: 2

Answer

Engineering, 03.07.2019 14:10

The y form of iron is known as: a) ferrite b) cementite c) perlite d) austenite

Answers: 3

Answer

Engineering, 03.07.2019 14:10

If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.

Answers: 1

Answer

You know the right answer?

A horizontal structure consists of an 10-mm-thick layer of copper and an 10-mm-thick layer of alumin...

Questions