subject
Engineering, 16.10.2020 14:01 veronicatrejoaguiler

An inductor with an inductance of 6.8[μH] is connected in parallel with an ideal voltage source. At t = 0, the voltage source has a voltage of zero, and the energy stored in the inductor is zero. The voltage stays zero for 50[μs], and then the voltage of the voltage source increases instantaneously to 5[V]. Then, 10[μs] after that, the voltage source decreases instantaneously to a value of -2[V]. Finally, 20[μs] later the voltage source instantaneously returns to zero, and stays at that value. In summary, the voltage makes three step jumps in value, at 50[μs], at 60[μs], and at 80[μs] after t = 0. Required:
a. Find expressions for the energy stored in the inductor, as a function of time, for the time period 0 < t < 100[μs].
b. Plot the energy stored in the inductor, as a function of time, for the time period 0 < t < 100 [μs].

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Coiled springs ought to be very strong and stiff. si3n4 is a strong, stiff material. would you select this material for a spring? explain.
Answers: 2
question
Engineering, 04.07.2019 18:10
Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise
Answers: 3
question
Engineering, 04.07.2019 18:10
For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater
Answers: 3
question
Engineering, 04.07.2019 18:10
Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.
Answers: 3
You know the right answer?
An inductor with an inductance of 6.8[μH] is connected in parallel with an ideal voltage source. At...
Questions
question
History, 14.10.2019 23:00
question
Mathematics, 14.10.2019 23:00
Questions on the website: 13722363