subject
Engineering, 17.10.2020 19:01 kristygodwin

A fuel cell is an electrochemical device that reacts hydrogen with oxygen from the air to produce water and DC electricity. A proposed application is replacement of the gasoline-fueled internal combustion engine in an automobile with a 100 kW fuel cell. You are on a summer internship with a gas supplier planning to transport hydrogen to service stations for use in cars powered by fuel cells. The hydrogen is to be transported in tube trailers, each of which has 10 tubes of length 10.5 m and diameter 0.56 m. Hydrogen in the tubes at 2600 psig and an average temperature of 298 K is discharged at service stations to a final pressure of 55 psig. Refueling each fuel-cell-powered automobile is estimated to require 4.0 kg of hydrogen.

a) You and your office-mate—an intern from a different university—have been asked to estimate the number of automobiles that can be refueled by one tube-trailer load of hydrogen. He does a very quick calculation and comes up with a value of 95 cars. Speculate how he did it and provide support for your speculation. What was his mistake?

b) Do the calculation using the law of corresponding states instead. (remember that for hydrogen and helium adjusted critical temperature and pressure values should be used)

ansver
Answers: 3

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Apiston-cylinder with a volume of 0.25 m3 holds 1 kg of air (r 0.287 k/kgk) at a temperature of 100 c. heat transfer to the cylinder causes an isothermal expansion of the piston until the volume triples. how much heat is added to the piston-cylinder?
Answers: 3
question
Engineering, 03.07.2019 15:10
If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.
Answers: 1
question
Engineering, 04.07.2019 03:10
What precautions should you take to prevent injuries when dealing with heavy loads?
Answers: 1
question
Engineering, 04.07.2019 18:10
Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10
Answers: 1
You know the right answer?
A fuel cell is an electrochemical device that reacts hydrogen with oxygen from the air to produce wa...
Questions
question
Mathematics, 28.01.2021 19:10
question
Mathematics, 28.01.2021 19:10
Questions on the website: 13722359