Engineering, 22.10.2020 16:01 eggoysters

Represent kg/μmin the correct SI form using an appropriate prefix. Represent in the correct SI form using an appropriate prefix. Mg/mGg/m mg/mkg/mng/mg/mSubmitMy AnswersGive UpIncorrect; Try Again; 2 attempts remainingPart BRepresent mN/μs in the correct SI form using an appropriate prefix. Represent in the correct SI form using an appropriate prefix. N/smN/s kN/sMN/sμN/snN/sSubmitMy AnswersGive UpPart CRepresent nm⋅Gg in the correct SI form using an appropriate prefix. Represent in the correct SI form using an appropriate prefix. mm⋅kgm⋅kgμm⋅kgMm⋅kgkm⋅kgl

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Amass of 1.5 kg of air at 120 kpa and 24°c is contained in a gas-tight, frictionless piston-cylinder device. the air is now compressed to a final pressure of 720 kpa. during the process, heat is transferred from the air such that the temperature inside the cylinder remains constant. calculate the boundary work input during this process.

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Abarometer contains mercury with a density of 13600 kg/m3. atmospheric conditions are 95.8 kpa and 20 °c at 20 °c, the vapor pressure of the mercury is 0.000173 kpa. the column of mercury will rise to a height of most nearly. select one: a)- 0.38 m b)- 0.82 m c)- 0.48 m d)- 0.72 m

Answers: 1

Answer

Engineering, 04.07.2019 19:10

The air in an automobile tire with a volume of 0.015 m3 is at 32°c and 140 kpa gage. determine the amount of air that must be added to raise the pressure to the recommended value of 206 kpa gage. assume the atmospheric pressure to be 128 kpa and the temperature and the volume to remain constant.[r-0.287 kj/kgk]

Answers: 3

Answer

Engineering, 06.07.2019 02:30

1in2 processor chip can be modelled as an isothermal plane wall of silicon, isothermal on both sides. the power input to the bottom of the plane wall, or the processing power of the chip, often called the thermal design power (tdp), is 100w. assume the periphery is adiabatic. the silicon is 400 microns thick. the temperature at the junction, or in this case on the bottom of the isothermal plane wall, is 85°c. what is the top surface temperature, assuming that the only mode of heat transfer is conduction

Answers: 1

Answer

You know the right answer?

Represent kg/μmin the correct SI form using an appropriate prefix. Represent in the correct SI form...

Questions