Engineering, 28.10.2020 16:40 gracebuffum

Barcelona has an instruction count of 2.389E12, an execution time of 750 s, and areference time of 9650 s.1.11.1 [5] <§§1.6, 1.9> Find the CPI if the clock cycle time is 0.333 ns.1.11.2 [5] <§1.9> Find the SPECratio.1.11.3 [5] <§§1.6, 1.9> Find the increase in CPU time if the number of instructionsof the benchmark is increased by 10% without affecting the CPI.1.11.4 [5] <§§1.6, 1.9> Find the increase in CPU time if the number of instructionsof the benchmark is increased by 10% and the CPI is increased by 5%.1.11.5 [5] <§§1.6, 1.9> Find the change in the SPECratio for this change.1.11.6 [10] <§1.6> Suppose that we are developing a new version of the AMDBarcelona processor with a 4 GHz clock rate. We have added some additionalinstructions to the instruction set in such a way that the number of instructionshas been reduced by 15%. The execution time is reduced to 700 s and the newSPECratio is 13.7. Find the new CPI.1.11.7 [10] <§1.6> Th

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 19:30

When using the ohmmeter function of a digital multimeter, the leads are placed in what position relative to the component being tested? a. parallel b. control c. series d. line

Answers: 3

Answer

Engineering, 04.07.2019 16:10

An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)

Answers: 2

Answer

Engineering, 04.07.2019 18:10

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way

Answers: 2

Answer

You know the right answer?

Barcelona has an instruction count of 2.389E12, an execution time of 750 s, and areference time of 9...

Questions