Engineering, 04.11.2020 18:00 Reese8802

. A normal-weight concrete has an average compressive strength of 20 MPa. What is the estimated flexure strength

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Have a greater impact on maintenance productivity than any other support group. (clo5) a)-the top management b)-inventory and purchasing c)-sub-contracting d)-cmms

Answers: 2

Answer

Engineering, 04.07.2019 19:20

Acompressor compresses a gas, a pump compresses a liquid. for a given pressure ratio, why does it take more work to compress a gas in a compressor than a liquid in a pump? a)- for a given pressure ratio the average specific volume for a gas is much higher than the average specific volume for a liquid. b)- there is no difference. the only difference is the amount of heat generated (not work) c)- for a given pressure ratio the average volurge for a gas is much higher than the average volume for a liquid. d)-there is no difference

Answers: 3

Answer

Engineering, 06.07.2019 04:20

An insulated tank truck containing 50,000 pounds of double-distilled, deionized water at 30 °c is pumped into a closed, refrigerated storage tank maintained at 5 °c in a facility located on top of mount mitchell, north carolina (elevation 6,684 feet & average july temperature of 84 °f). a)-determine the volume of the storage tank required to hold the purified water. b)- determine the initial and final pressure differences that must be overcome by a liquid pump assuming the storage tank initially contains air at 5 °c. assume the air is slowly bled out of the storage tank during the water transfer c.) during a routine operation today, the tank is slightly ruptured by a stainless steel pipe and a water acrosol of droplets begins to spray out of the storage tank. state all assumptions and determine the internal pressure within the water droplets produced

Answers: 1

Answer

You know the right answer?

. A normal-weight concrete has an average compressive strength of 20 MPa. What is the estimated flex...

Questions