Engineering, 06.11.2020 01:00 Malari4445

The essay or report should: Name the product and briefly describe it. Identify the types of engineering that would be used to develop the product. Describe how you would apply the stages of the product life cycle to your product. Generally describe the steps that you would take within each step, using your product as an example. End with a short conclusion based on what you believe the outcome would be if you followed the product development life cycle process. (I NEED IT FAST AND IT NEEDS TO BE ANYTHING AND IF YOU JUST PUT A RANDOM THING YOU WILL BE REPORTED AND JUST PLEASE PUT YOUR BEST ANSWER! ILL MARK YOU AS BRAINLIEST)

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

When at a point two solid phase changes to one solid phase on cooling then it is known as a) eutectoid point b) eutectic point c) peritectic point d) peritectoid point

Answers: 3

Answer

Engineering, 04.07.2019 19:10

An engine, weighing 3000 n, is supported on a pedestal mount. it has been observed that the engine induces vibration into the surrounding area through its pedestal at the maximum operating speed. determine the stiffness of the dynamic vibration absorber spring in (n/m) that will reduce the vibration when mounted on the pedestal. the magnitude of the exciting force is 250 n, and the amplitude of motion of the auxiliary mass is to be limited to 2 mm note: in this question type-in right numbers, no decimals, no fractions, no unit. approximate to right number if needed

Answers: 3

Answer

Engineering, 06.07.2019 04:30

What is the principle of operation of a mechanical dynamometer?

Answers: 1

Answer

Engineering, 06.07.2019 05:10

The ivanpah solar thermal power plant cost $2.2 billion to build. the gross plant electric output is 392 mw, and the net output is 377 mw. the planned capacity factor was 27.4%, but the actual capacity factor in 2016 was 20.5%. at best the plant thermal efficiency appears to be 18%. in addition, for the daily startup process, the solar plant also burned 1.3x10^12 btu of natural gas in 2016. the cost of natural gas in 2016 was about $2.5 per million btu. assuming a levelized annual fixed charge rate of 7%, determine (a) the capital cost (c/kwh) and (b) the fuel cost (e/k wh) for the electricity in 2016.

Answers: 3

Answer

You know the right answer?

The essay or report should: Name the product and briefly describe it. Identify the types of engineer...

Questions