Engineering, 11.11.2020 03:30 Naara21

Realizar la investigación correspondiente 1.- COMPENSACION DEL DIAMETRO DE LA HERRAMIENTA (G40, G41, G42).

A.- MÉTODO DEL COAMANDO DE LA COMPENSACIÓN DE LA HERRAMIENTA

B.- MOVIMIENTO DE LA HERRAMIENTA EN LA COMPENSACIÓN DE SU DIÁMETRO.

1.- MODO DE CANCELACIÓN

2.- ARRANQUE (START-UP)

3.- MODO DE COMPENSACIÓN

4.- CANCELACIÓN DE LA COMPENSACIÓN (OFFSET CANCEL)

C.- ASPECTOS QUE DEBEN CONSIDERARSE INDEPENDIENTEMENTE DE LA COMPENSACIÓN DEL DIÁMETRO DE LA HERRAMIENTA.

1.- CAMBIO DE LA CANTIDAD DE COMPENSACIÓN

2.- CANTIDAD DE COMPENSACIÓN POSITIVA Y NEGATIVA

3.- CAMBIO DEL MODO DE COMPENSACIÓN

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?

Answers: 3

Answer

You know the right answer?

Realizar la investigación correspondiente 1.- COMPENSACION DEL DIAMETRO DE LA HERRAMIENTA (G40, G41...

Questions