subject
Engineering, 11.11.2020 17:50 LaneyMM1401

We want to assess how far engine designed/manufacturers have progressed over the last 100 years. Consider the Ford Model T, the first mass produced automobile which began production in 1908. With the equipped engine, the Model T was capable of a max speed of 45 mph. Engine Model TBore [mm] 95.25Stroke [mm] 101.6Comp. Ratio [-] 3.98Power [hP] 20Speed [rpm] 1750Config. I4Induction Nat. Asp. Fuel Gasoline Cycle 4-Stroke1. Ford claims the Model T achieved fuel economy on the order of 13-21 mpg. Assuming the average of this range (i. e. 17 mpg), determine the fuel consumption in [gal/hr] of the engine at the maximum vehicle speed of 45 mph.2. Calculate the brake specific fuel consumption in [g/kW-hr] at rated power and max vehicle speed. (rhogasoline = 0.75 g/mL, 1 gal = 3785.4 mL, 1 hP = 0.7457 kW).3. If the heating value of gasoline is 42 MJ/kg, and given the answer to the previous part, determine the brake efficiency at these operatingconditions.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Apipe with an outside diameter of 15 cm is exposed to an ambient air and surrounding temperature of -20°c. the pipe has an outer surface temperature of 65°c and an emissivity of 0.85. if the rate of heat loss from the pipe surface is 0.95 kw per meter of length, the external convective heat transfer coefficient (h) is: (a) 12.5 w/m"k (b) 18.6 w/mk (c) 23.7 w/mk (d) 27.9 w/mk (e) 33.5 w/mk
Answers: 1
question
Engineering, 04.07.2019 18:20
Derive the correction factor formula for conical nozzle i=-(1+ cosa) and calculate the nozzle angle correction factor for a nozzle whose divergence hal-fangle is 13 (hint: assume that all the mass flow originates at the apex of the cone.
Answers: 3
question
Engineering, 04.07.2019 18:20
Athin walled concentric tube exchanger is used to cool engine oil from 160°c to 60°c with water that is available at 25°c acting as a coolant. the oil and water flow rates are each at 2 kg/s, and the diameter of the inner tube is 0.5 m and the corresponding value of the overall heat transfer coefficient is 250 w/m2. oc. how long must the heat exchanger be to accomplish the desired cooling? cpwater=4.187 kj/kg-candcpengine el=2.035 kj/kg·°c, oil . 120]
Answers: 1
question
Engineering, 04.07.2019 19:10
What is the major difference between thermoplastics and thermosetting plastics from the polymerization structure point of view?
Answers: 2
You know the right answer?
We want to assess how far engine designed/manufacturers have progressed over the last 100 years. Con...
Questions
question
Mathematics, 17.11.2019 03:31
question
Mathematics, 17.11.2019 03:31
question
Mathematics, 17.11.2019 03:31
question
Mathematics, 17.11.2019 03:31
Questions on the website: 13722361