subject
Engineering, 12.11.2020 17:50 nylahnwalker

1. In an internal combustion engine, fuel is burned the engine.
2. In the
stroke of the four-stroke cycle, the piston rises, compressing the air-and-
fuel mixture trapped in the combustion chamber.
3. In an engine, the stroke is the distance the piston
4. When a piston is at its lowest position in the cylinder, it's said to be at
5. During the
stage of engine operation, gases are released from the cylinder.
6. A four-stroke engine will contain at least two mechanical valves called the
valve
and the
valve
7. In the
stroke of the four-stroke cycle, air mixed with fuel is drawn into the
cylinder.
8. The total engine
I is stated as the volume of the space swept through by all the
pistons.
9.
A two-stroke engine completes all four stages of engine operation in four piston
strokes
10. During the
stroke of the four-stroke cycle, the mixture of air and fuel is ignited,
and the contained explosion of the fuel presses the piston back down in the cylinder.
11. The top of a cylinder is sealed by the cylinder
12. The
is the ratio of the total cylinder volume to the clearance volume.

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.
Answers: 1
question
Engineering, 04.07.2019 18:10
Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10
Answers: 1
question
Engineering, 04.07.2019 18:10
Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines
Answers: 1
question
Engineering, 04.07.2019 18:20
Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?
Answers: 3
You know the right answer?
1. In an internal combustion engine, fuel is burned the engine.
2. In the
stroke of the...
Questions
question
Mathematics, 05.09.2020 03:01
question
Mathematics, 05.09.2020 03:01
Questions on the website: 13722362