Engineering, 12.11.2020 19:10 lizzyhearts
A cylindrical tank, 0.42 m in diameter, drains through a hole in its bottom. At the instant when the water depth is 0.73 m, the flow rate from the tank is observed to be 5 kg/s. Determine the rate of change of water level at this instant.
Answers: 3
(1)
- Current mass of water inside the tank, measured in kilograms.
- Diameter of the cylindrical tank, measured in meters.
- Depth of the water in the tank, measured in meters.
), measured in kilograms per second, by considering geometric characteristics of the cylinder (
) and the fact that water is an incompressible fluid (
):
(2)
is the rate of change of water level, measured in meters per second. 
, 
and 
, then the rate of change of water level is:
![\frac{dh}{dt} = \left[\frac{4}{\pi\cdot \left(1000\,\frac{kg}{m^{3}} \right)\cdot (0.42\,m)^{2}} \right]\cdot (-5\,\frac{kg}{s} )](/tpl/images/0891/7312/4db3a.png)
Another question on Engineering
Engineering, 04.07.2019 18:10
Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.
Answers: 1
Engineering, 04.07.2019 18:10
Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux
Answers: 3
Engineering, 04.07.2019 18:20
Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.
Answers: 1
Engineering, 04.07.2019 19:10
The air in an automobile tire with a volume of 0.015 m3 is at 32°c and 140 kpa gage. determine the amount of air that must be added to raise the pressure to the recommended value of 206 kpa gage. assume the atmospheric pressure to be 128 kpa and the temperature and the volume to remain constant.[r-0.287 kj/kgk]
Answers: 3
You know the right answer?
A cylindrical tank, 0.42 m in diameter, drains through a hole in its bottom. At the instant when the...
Questions
English, 15.10.2019 05:30
Mathematics, 15.10.2019 05:30
Mathematics, 15.10.2019 05:30
Biology, 15.10.2019 05:30
English, 15.10.2019 05:30
Health, 15.10.2019 05:30
Advanced Placement (AP), 15.10.2019 05:30
Physics, 15.10.2019 05:30
Mathematics, 15.10.2019 05:30
History, 15.10.2019 05:30
Biology, 15.10.2019 05:30
History, 15.10.2019 05:30
