Engineering, 29.11.2020 14:40 BREBRE8932

A three-phase 80 kVA transformer is rated to a primary voltage of 2.2 kV and a secondary voltage of 220 V. The transformer parameters are determined by open and short circuit tests. The results of the open and short circuit tests are: Short-Circuit Test (low-voltage side short-circuited; data measured at high-voltage side):
Vsc = 48 V Isc = 32 A Psc = 800 W
Open-Circuit Test (high-voltage side open; data measured at low-voltage side):
Voc = 220 V Ioc = 5.7 A Poc = 220 W

Required:
a. Determine the parameters of the equivalent circuit. Draw the equivalent circuit of the transformer.
b. Plot the voltage regulation and efficiency versus the load for both lagging and leading power factors of 0.6, 0.8, and 0.9. Obtain the maximum efficiency values. Assume the load voltage is equal to the rated secondary voltage of the transformer.
c. Assuming the primary rated voltage is being supplied to the transformer, determine the load voltage when the transformer carries half-load and the power factor is 0.8, both lagging and leading.

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Amass of m 1.5 kg of steam is contained in a closed rigid container. initially the pressure and temperature of the steam are: p 1.5 mpa and t 240°c (superheated state), respectively. then the temperature drops to t2= 100°c as the result of heat transfer to the surroundings. determine: a) quality of the steam at the end of the process, b) heat transfer with the surroundings. for: p1.5 mpa and t 240°c: enthalpy of superheated vapour is 2900 kj/kg, specific volume of superheated vapour is 0. 1483 m/kg, while for t 100°c: enthalpy of saturated liquid water is 419kj/kg, specific volume of saturated liquid water is 0.001043m/kg, enthalpy of saturated vapour is 2676 kj/kg, specific volume of saturated vapour is 1.672 m/kg and pressure is 0.1 mpa.

Answers: 3

Answer

Engineering, 03.07.2019 14:10

Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Consider a large isothermal enclosure that is maintained at a uniform temperature of 2000 k. calculate the emissive power of the radiation that emerges from a small aperture on the enclosure surface. what is the wavelength ? , below which 10% of the emission is concentrated? what is the wavelength ? 2 above which 10% of the emission is concentrated? determine the wavelength at which maximum spectral emissive power occurs. what is the irradiation incident on a small object placed inside the enclosure?

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Assuming compressible flow of air and that the measurements are done at flagstaff a pitot static tube that gives the difference of total and static pressure measures 0.35 m of mercury. what is the velocity of air? assume the temperature to be 300k. (submit your excel or matlab calculation sheet)

Answers: 1

Answer

You know the right answer?

A three-phase 80 kVA transformer is rated to a primary voltage of 2.2 kV and a secondary voltage of...

Questions