Engineering, 04.12.2020 18:50 kdfawesome5582

HURR Thea and a client are discussing the design for the client’s new office building. The client wants the building to embody her company’s commitment to forward-thinking technology and new ideas. Thea proposes the use of sheets of ethylene tetrafluoroethylene (ETFE), a fluorocarbon-based polymer, for the new building instead of glass. The client has never heard of ETFE and is skeptical. How might Thea convince the client to go with ETFE? (Select all that apply.)

Emphasize that ETFE is not new but has been in use since the 1970s.

Talk about its use as a material for aeronautic insulation.

Explain that ETFE is like glass only better, transmitting more light while weighing and costing much less.

Remind the client that she wants her building to embody a commitment to innovation.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:20

Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa.s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)

Answers: 3

Answer

Engineering, 04.07.2019 19:20

List 3 options on how to reduce knocking problens during engine process,

Answers: 2

Answer

Engineering, 04.07.2019 19:20

Air at a pressure of 1atm and a temperature of 40 c is in parallel flow over the top surface of a flat plate that is heated to a uniform temperature of 120 c. the plate has a length of 0.40m (in the flow direction) and a width of 0.15m. the reynolds number based on the plate length is 50, 000. what is the rate of heat transfer from the plate to the air? if the free stream velocity of the air is doubled and the pressure is increased to 10 atm what is the rate of heat transfer?

Answers: 2

Answer

Engineering, 06.07.2019 03:10

Steel balls 12 mm in diameter are annealed by heating to 1150 k and then slowly cooled to 400 k in an air att 325 k and h -20 w/m2 k. assume the properties of the steel to be k- 40 w/m k,p 7800 kg/m3, and cp 600 j/kg k. a. determine whether lumped system method can be used to analyze this problem and if so why" b. determine the time required for the cooling process. c. determine the total amount of heat lost from each ball to the ambient air

Answers: 1

Answer

You know the right answer?

HURR Thea and a client are discussing the design for the client’s new office building. The client w...

Questions