Engineering, 05.12.2020 18:40 KittehMeow6039

How to change between power-optimized and energy-optimized in a battery?

Answers: 3

Show answers

Answers

Answer from: naenae2cold12021

Batteries are non-ideal energy sources - minimizing the energy consumption of a battery-powered system is not equivalent to maximizing its battery life. We propose an alternative interpretation of a previously proposed battery model, which indicates that the deviation from ideal behavior is due to the buildup of "unavailable charge" during the discharge process. Previously, battery-aware task scheduling algorithms and power management policies have been developed, which try to reduce the unavailable charge at the end of a given workload. However, they do not account for the occurrence of rest periods (user enforced, naturally occurring, or due to finite load horizon), which are present in a variety of workloads. We first obtain an analytical bound on the recovery time of a battery as a function of the extent of recovery. Then, we shown that the effect of the rest periods is to reduce the improvement of battery-charge optimizing techniques over traditional energy-optimizing techniques. Under certain conditions, the policy that only minimizes energy consumption can actually achieve a longer battery lifetime than a battery-aware policy. A formal criterion based on the recovery time is proposed to choose between a candidate battery-aware policy and a candidate energy-aware policy. We also model the battery discharge process as a linear time invariant system and obtain the frequency response of a battery. This is then used to study the effect of task granularity on the improvement achieved by battery-aware task scheduling. It was observed that the response time of typical batteries are of the order of seconds to several minutes. This, along with the charge recovery effect, was seen to cause battery-aware task scheduling methods to become ineffective for both very fine-grained (less than 10 ms) and very coarse-grained (greater than 30 mm) task granularities.

Explanation:

Answer from: Quest

explanation:

i don't understand really? can u provide more information

u should make a machine that can make ice cream fresh!

Answer from: Quest

The main difference between gui and cli is that the graphical user interface (gui) allows the user to interact with the system using graphical elements such as windows, icons, menus while the command line interface (cli) allows the user to interact with the system using commands

Another question on Engineering

Engineering, 04.07.2019 18:20

Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um

Answers: 2

Answer

Engineering, 04.07.2019 19:10

The air in an automobile tire with a volume of 0.015 m3 is at 32°c and 140 kpa gage. determine the amount of air that must be added to raise the pressure to the recommended value of 206 kpa gage. assume the atmospheric pressure to be 128 kpa and the temperature and the volume to remain constant.[r-0.287 kj/kgk]

Answers: 3

Answer

Engineering, 04.07.2019 19:20

Air at a pressure of 1atm and a temperature of 40 c is in parallel flow over the top surface of a flat plate that is heated to a uniform temperature of 120 c. the plate has a length of 0.40m (in the flow direction) and a width of 0.15m. the reynolds number based on the plate length is 50, 000. what is the rate of heat transfer from the plate to the air? if the free stream velocity of the air is doubled and the pressure is increased to 10 atm what is the rate of heat transfer?

Answers: 2

Answer

Engineering, 06.07.2019 02:30

Precipitation hardening can be achieved in many light alloys by a three-step heat treatment. what is carried out and what is the purpose at each step? why is such a treatment necessary based on the nucleation and growth theory of phase transformation. compare this treatment with tempering martensite for carbon steels (similarities and differences).