Plz join my zoom meeting im bored
Meeting ID: 972 063 3036
Passcode: 5mA05J...
Engineering, 08.12.2020 02:10 kaylamcph7844
Plz join my zoom meeting im bored
Meeting ID: 972 063 3036
Passcode: 5mA05J
Answers: 1
Engineering, 03.07.2019 15:10
If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.
Answers: 1
Engineering, 04.07.2019 18:10
For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater
Answers: 3
Engineering, 04.07.2019 18:10
Items are similar to the free issue items, but their access is limited. (clo5) a)-bin stock items free issue b)-bin stock controlled issue c)-critical or insurance spares d)-rebuildable spares e)-consumables
Answers: 1
Engineering, 04.07.2019 18:20
Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um
Answers: 2
Mathematics, 03.12.2021 01:00
Computers and Technology, 03.12.2021 01:00
Social Studies, 03.12.2021 01:00
Mathematics, 03.12.2021 01:00
Mathematics, 03.12.2021 01:00
Mathematics, 03.12.2021 01:00
Mathematics, 03.12.2021 01:00
Mathematics, 03.12.2021 01:00
Mathematics, 03.12.2021 01:00
Mathematics, 03.12.2021 01:10