Engineering, 08.12.2020 22:40 Jorjalilli8081
Help quick plz! So during the quarintine i made a rocket ship out of cardboard cuz in a show i used to watch they made a card board rocket ship and it worked so i thought mine would work too. so i made an engine with plastic bottles (cuz of bottle rockets duh) and then i filled them with gasoline and set it on fire and blast off! but that didn't work the card board box caught on fire and cuz of the fumes from the plastic bottle i passed out. also this is free points. but then when i woke up (which was 2 minutes ago) and my house was all shiny and very very warm. why did that happen? i need help NOW!
Answers: 3
Another question on Engineering
Engineering, 04.07.2019 18:10
Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.
Answers: 2
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 18:10
The flow rate of air through a through a pipe is 0.02 m5/s. a pitot static tube is placed in the flow. the radius of the pitot static tube is 1 mm. assuming the flow to be steady and the air to be at 300k, calculate the difference in total and static pressure if the diameter of the pipe is: (a) d 0.1 m d 0.05 m (c) d 0.01 m
Answers: 2
Engineering, 04.07.2019 18:20
Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um
Answers: 2
You know the right answer?
Help quick plz!
So during the quarintine i made a rocket ship out of cardboard cuz in a show i used...
Questions
Mathematics, 04.03.2020 02:23
Mathematics, 04.03.2020 02:23
Engineering, 04.03.2020 02:24
English, 04.03.2020 02:24
