subject
Engineering, 10.12.2020 02:10 jweldene12

Edit Tools Help
1. In your words, what is the binary system?
Binary Numbering ..
2. A byte contains 8 bits of data, What is the highest possible number that can be
represented in a byte? Explain your answer.
3. Write each of the following in a byte using binary:
a. Birth Month (as a number):
b. Birth Day of the month):
I c. Age:
4. A DC motor receives voltage from an 8-bit, 5V Arduino. If the voltage signal ranges from
0-5V, by how much does the voltage increase as the byte increases by 1? (HINT: Think
about the maximum number in a byte and the maximum voltage)
5. For the DC motor in question 4, if you want to send 3V to the motor, then to what value
should you set the Arduino Pin?
6. Write the answer from question 5 as a byte in binary.
7. Determine how many bits the Temperature sensor sends. (HINTA find the maximum
voltage sent by the sensor and find the value read by the Arduino at that voltage.)
DEC
9
w

ansver
Answers: 2

Another question on Engineering

question
Engineering, 03.07.2019 15:10
If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.
Answers: 1
question
Engineering, 04.07.2019 18:10
Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way
Answers: 2
question
Engineering, 04.07.2019 18:10
Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.
Answers: 3
question
Engineering, 04.07.2019 18:20
Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?
Answers: 2
You know the right answer?
Edit Tools Help
1. In your words, what is the binary system?
Binary Numbering ..
...
Questions
question
Social Studies, 25.07.2019 21:40
Questions on the website: 13722363