subject
Engineering, 10.12.2020 16:30 nallaico585

Technician a says to use the appropriate seal driver to install the new seal, technician b says most anxel nuts used on tappered roller bearing spindles are torqued to over 300 foot pounds.
who is correct?

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Assuming compressible flow of air and that the measurements are done at flagstaff a pitot static tube that gives the difference of total and static pressure measures 0.35 m of mercury. what is the velocity of air? assume the temperature to be 300k. (submit your excel or matlab calculation sheet)
Answers: 1
question
Engineering, 04.07.2019 18:20
Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis
Answers: 1
question
Engineering, 04.07.2019 18:20
For a gate width of 2 m into the paper, determine the force required to hold the gate abc at its location.
Answers: 1
question
Engineering, 04.07.2019 19:10
An electric kettle is made out of stainless steel, weighs two pounds (when empty) and is equipped with a heating element that consumes 2 kw of electricity. assuming that the water and the kettle are at the same uniform temperature at any moment of time, calculate the shortest possible time to bring 2 quarts of water from room temperature to the onset of boiling
Answers: 2
You know the right answer?
Technician a says to use the appropriate seal driver to install the new seal, technician b says mos...
Questions
question
Mathematics, 11.02.2021 20:40
question
Mathematics, 11.02.2021 20:40
question
Mathematics, 11.02.2021 20:40
question
Mathematics, 11.02.2021 20:40
question
Mathematics, 11.02.2021 20:40
Questions on the website: 13722361