Engineering, 11.12.2020 01:00 mjstew00763

Define a separate subroutine for each of the following tasks respectively. A) Swap the most significant bit (msb) of registered AH And the Least significant Bit (Lsb) of registered AL.

B) Check the msb of AL and LSB of BL. if they are equal, copy BL into AL. Otherwise copy AL in BL

C) set all the bits in LS Nibble and Invert All bits in the MS nibble of the word at offset address 0400H in the data segment.

D) multiply the byte at offset address 0100h with the byte at offset address 0200h. save the result at offset address 0300h in the data segment.

pls answer i took hours to write these

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

True or false (explain) (110)[111] is a slip system in bcc metals . the {111} family in fcc contains 8 planes. resolved shear stress (rss) in single crystals is just related to the applied stress. critical resolved shear stress (crss) in single crystal metals is direct proportional to the number of defects in the structure

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?

Answers: 2

Answer

You know the right answer?

Define a separate subroutine for each of the following tasks respectively. A) Swap the most signifi...

Questions