It’s that wop, that mm, that f did I do. Got me mm mm on good.
...
Engineering, 15.12.2020 02:20 wildfox479
It’s that wop, that mm, that f did I do. Got me mm mm on good.
Answers: 2
Another question on Engineering
Engineering, 03.07.2019 19:30
When using the ohmmeter function of a digital multimeter, the leads are placed in what position relative to the component being tested? a. parallel b. control c. series d. line
Answers: 3
Engineering, 04.07.2019 18:10
Fluids at rest possess no flow energy. a)- true b)- false
Answers: 3
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
You know the right answer?
Questions
Mathematics, 28.05.2021 05:50
Mathematics, 28.05.2021 05:50
History, 28.05.2021 05:50
Mathematics, 28.05.2021 05:50
Biology, 28.05.2021 05:50
History, 28.05.2021 05:50
English, 28.05.2021 05:50
Spanish, 28.05.2021 05:50
Mathematics, 28.05.2021 05:50
Geography, 28.05.2021 05:50
