subject
Engineering, 31.12.2020 03:10 jonathanmalone

Technician A states that a pressure bleeder may be needed to bleed EBC system hydraulic circuits. Technician B states that once the scan tool indicates that the HCU is bled, it may direct you to bleed the brakes manually to remove any remaining air from the system. Who is correct

ansver
Answers: 2

Another question on Engineering

question
Engineering, 03.07.2019 14:10
Amass of 1.5 kg of air at 120 kpa and 24°c is contained in a gas-tight, frictionless piston-cylinder device. the air is now compressed to a final pressure of 720 kpa. during the process, heat is transferred from the air such that the temperature inside the cylinder remains constant. calculate the boundary work input during this process.
Answers: 2
question
Engineering, 06.07.2019 03:20
Aload of 10kn is to be suddenly applied to the free end of a vertical rod of length 500 mm, the upper end being rigidly fixed. 190 mechanical science what should the diameter of the rod be if the maximum stress in the rod is not to exceed 100 mpa? the tensile modulus of the rod is 205 gpa.
Answers: 2
question
Engineering, 06.07.2019 03:30
An ammonia compressor has a 5% clearance volume and displacement rate of 80 l/s and pumps against a condensing temperature of 40°c. for two different temperatures of -10°c and 10°c, compute the mass flow rate of refrigerant assuming the clearance volumetric efficiency applies. discharge specific volume corresponding to-10°c and 10°c are 112.5 l/kg and 95 l/kg, respectively.
Answers: 2
question
Engineering, 06.07.2019 05:10
Asteam turbine is supplied with steam at 28bar and 425c. a fraction of the steam is extracted at 1.2bar to heat the feed water in one open feed water heater. the rest of the steam expands in the low pressure stage of the turbine to 0.08bar. a)-sketch the regenerative rankine cycle with open feed water heater on the t-s diagram. b)-assuming isentropic expansion in both stages of the turbine, find the cycle efficiency. do not assume negligible pump work.
Answers: 1
You know the right answer?
Technician A states that a pressure bleeder may be needed to bleed EBC system hydraulic circuits. Te...
Questions
question
Mathematics, 03.07.2019 15:00
question
Mathematics, 03.07.2019 15:00
Questions on the website: 13722360