Engineering, 11.01.2021 08:10 nickeymcorrea
) An extrusion die is used to produce aluminum rods. Specifications are given for the length and the diameter of the rods. For each rod, the length is classified as too short, too long, or OK, and the diameter is classified as too thin, too thick, or OK. In a population of 1000 rods, the number of rods in each class is as follows:
Answers: 1
Engineering, 03.07.2019 14:10
The y form of iron is known as: a) ferrite b) cementite c) perlite d) austenite
Answers: 3
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
Engineering, 04.07.2019 18:10
What difference(s) did you notice using a pneumatic circuit over hydraulic circuit.explain why the pneumatic piston stumbles when it hits an obstacle.
Answers: 2
Engineering, 04.07.2019 18:10
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
) An extrusion die is used to produce aluminum rods. Specifications are given for the length and the...
Mathematics, 20.05.2020 04:03
Mathematics, 20.05.2020 04:03
Health, 20.05.2020 04:03
Biology, 20.05.2020 04:03
Biology, 20.05.2020 04:03
Mathematics, 20.05.2020 04:03
Mathematics, 20.05.2020 04:03
History, 20.05.2020 04:04
Mathematics, 20.05.2020 04:04
Biology, 20.05.2020 04:04
Mathematics, 20.05.2020 04:04
Mathematics, 20.05.2020 04:04
Computers and Technology, 20.05.2020 04:04