Engineering, 15.01.2021 08:20 Pbaer3087

The following equations estimate the calories burned when exercising (source): Men: Calories = ( (Age x 0.2017) — (Weight x 0.09036) + (Heart Rate x 0.6309) — 55.0969 ) x Time / 4.184

Women: Calories = ( (Age x 0.074) — (Weight x 0.05741) + (Heart Rate x 0.4472) — 20.4022 ) x Time / 4.184

Write a program using inputs age (years), weight (pounds), heart rate (beats per minute), and time (minutes), respectively. Output calories burned for men and women.

Output each floating-point value with two digits after the decimal point, which can be achieved as follows:
print('Men: %0.2f calories' % calories_man)

Ex: If the input is:

49
155
148
60
Then the output is:

Men: 489.78 calories
Women: 580.94 calories

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

Answer

Engineering, 06.07.2019 03:20

An air-conditioning system consists of a heating section and an evaporative cooler. air enters the heating section at 10°c and 70 percent relative humidity at a rate of 30m^3/min, and it leaves the evaporative cooler at 20°c and 60 percent relatively humidity. if the air conditioning system operates at a total pressure of 98 kpa, determine (a) the temperature and relative humidity of the air when it leaves the heating section, (b) the rate of heat transfer in the heating section, and (c) the rate of water added to air in the evaporative cooler

Answers: 2

Answer

Engineering, 06.07.2019 04:10

Aspherical thermocouple measurement errors a spherical thermocouple made of constantin transfer coefficient between the gas and the thermocouple is h used to measure the temperature of a gas. the heat 400 w/m2 k. calculate the maximum diameter d of the thermocouple if the thermocouple's measurement error should be w 23 within 5% of the initial temperature difference in 5 seconds. for constantin, k 8920 kg/m3, and c 410 j/kg. k.

Answers: 3

Answer

Engineering, 06.07.2019 04:20

Two microscope slides are placed horizontally, one on top of the other, with a drop of a dishwashing liquid between them. the gap between the slides is 1 mm. a machine pulls the top slide to the right with a velocity of 0.15 millimeters per second while the bottom slide is held stationary. a stress gage indicates that a shearing stress of 0.5 pa is required to pull the top slide with this velocity. if the dishwashing liquid adheres to both slides during this process, what is the viscosity of the liquid? specify whether your answer is dynamic or kinematic viscosity, and use appropriate units.

Answers: 1

Answer

You know the right answer?

The following equations estimate the calories burned when exercising (source): Men: Calories = ( (A...

Questions