subject
Engineering, 15.01.2021 16:00 mustachegirl311

Jonathan Simpson owns a construction company. One day a subcontractor calls him, saying that he needs a replacement check for the job he completed at 1437 West Maple Avenue. Jonathan looks up the job on his accounting program and agrees to reissue the check for $12,750. The subcontractor says that the original check was for only $10,750. Jonathan looks around the office but can’t find the company checkbook or ledger. Only one other person has access to the accounting program. Jonathan calls you to investigate. How would you proceed? Write a one-page report detailing the steps Jonathan needs to take to gather the necessary evidence and protect his company.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 03.07.2019 15:10
If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.
Answers: 1
question
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
question
Engineering, 04.07.2019 18:10
Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2
Answers: 3
question
Engineering, 04.07.2019 18:10
Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.
Answers: 3
You know the right answer?
Jonathan Simpson owns a construction company. One day a subcontractor calls him, saying that he need...
Questions
question
Mathematics, 23.10.2020 01:01
question
Physics, 23.10.2020 01:01
question
Mathematics, 23.10.2020 01:01
question
Spanish, 23.10.2020 01:01
question
Advanced Placement (AP), 23.10.2020 01:01
question
Mathematics, 23.10.2020 01:01
question
Mathematics, 23.10.2020 01:01
Questions on the website: 13722363