Engineering, 19.01.2021 01:20 quay39

Please help this is due today 1. The purpose of process control is to
a. identify variables and discover the full range of results they produce.
b. ensure that the output is consistent every time the process is enacted.
c. allow chemical engineers to work successfully with those in other fields.
d. develop the management skills required to assist a chemical engineers in doing their job.

2. Some bioengineers majored in life sciences rather than engineering in college.
a. true
b. false

3. The principle of recycling applies only to open systems.
a. true
b. false

4. Why is chemical engineering one of the few areas of engineering seeing a decline?
a. it is very difficult field and that discourages people
b. the numerous safety requirements make it one of the dangerous professions
c. it requires a different education, skill set, and training than other engineering fields
d. manufacturing is declining in the U. S., and many chemical engineers work in this area

5. Human experimentation creates ethical issues in bioengineering.
a. true
b. false

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Amass of m 1.5 kg of steam is contained in a closed rigid container. initially the pressure and temperature of the steam are: p 1.5 mpa and t 240°c (superheated state), respectively. then the temperature drops to t2= 100°c as the result of heat transfer to the surroundings. determine: a) quality of the steam at the end of the process, b) heat transfer with the surroundings. for: p1.5 mpa and t 240°c: enthalpy of superheated vapour is 2900 kj/kg, specific volume of superheated vapour is 0. 1483 m/kg, while for t 100°c: enthalpy of saturated liquid water is 419kj/kg, specific volume of saturated liquid water is 0.001043m/kg, enthalpy of saturated vapour is 2676 kj/kg, specific volume of saturated vapour is 1.672 m/kg and pressure is 0.1 mpa.

Answers: 3

Answer

Engineering, 03.07.2019 14:10

If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.

Answers: 3

Answer

You know the right answer?

Please help this is due today 1. The purpose of process control is to
a. identify variables a...

Questions