Engineering, 19.01.2021 19:10 Jazzypooh9274

When designing an opto-coupler circuit for a CNC machine, the micro-controller much be able to interface with the opto-coupler in the limit stop when the bed has reached its extreme x-axis limit. Which of the following is true for the sensor and the micro-controller interface? A. None of the above as the sensor does not work with micro-controllers.
B. The output of the photo-transistor in the opto-coupler circuk can be directly connected to the micro-controllers input pin
C. A opto-coupler drar needs a smoothing cult before it can be interfaced with a mer oder due to the fact that the oplo-coupler le analog controller reasonal
D. The microcontroller cant interface with the phototransistor opto-coupler eroult since i analog and the more controller is digital

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented

Answers: 2

Answer

Engineering, 04.07.2019 18:10

You are making beer. the first step is filling the glass carboy with the liquid wort. the internal diameter of the carboy is 15 in., and you wish to fill it up to a depth of 2 ft. if your wort is drawn from the kettle using a siphon process that flows at 3 gpm, how long will it take to fill?

Answers: 1

Answer

You know the right answer?

When designing an opto-coupler circuit for a CNC machine, the micro-controller much be able to inter...

Questions