Engineering, 21.01.2021 05:20 joytheqt

Achieve a given revised spec The customer has a LED circuit box with the following configurations. An op-amp, a 1.5V
input battery, a iko input resistor and a 2kg feedback resistor It is used to light up a 1.2
to ZV LED with a 1000 resistor connected in series at output terminal "a" and "b".
Now the customer would like to use this box to operate with a total number of 6 different
changing the value of one of the components
colours of LEDs to make a light chain (6 LEDs connected in series) and place it in his office
reception. The output terminal voltage shall be increased to +12V. One more condition,
the company would like to have the circuit as simple as possible.
Note: An internal 15V battery pack is installed in the op-amp and so you do not need to
consider the power supply to the op-amp in your design.
t-
1.5V
100
b.
1. Briefly describe your design circuit which satisfying customer's requirement
(show your calculations if any) and how it works.
please help me

Achieve a given revised spec

The customer has a LED circuit box with the following configurations

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Apiston-cylinder with a volume of 0.25 m3 holds 1 kg of air (r 0.287 k/kgk) at a temperature of 100 c. heat transfer to the cylinder causes an isothermal expansion of the piston until the volume triples. how much heat is added to the piston-cylinder?

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Select any two (2) areas of applications of chain-drive. (clo4) a)-permanent lubrication necessary b)-hydraulic forklift truck operation c)-rigging and heavy moving materials d)-relatively high maintenance costs e)-costlier than belt drives

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Avolume of 2.65 m3 of air in a rigid, insulated container fitted with a paddle wheel is initially at 264 k, 5.6 bar. the air receives 432 kj by work from the paddle wheel. assuming the ideal gas model with cv = 0.71 kj/kg • k, determine for the air the amount of entropy produced, in kj/k

Answers: 2

Answer

You know the right answer?

Achieve a given revised spec The customer has a LED circuit box with the following configurations....

Questions