Engineering, 28.01.2021 23:10 homelanie21
A load of 175 lbs is applied to a beam having a moment of inertia of 13.65 in^4, with the length of the span between the sports for the beam being 2.5 ft. If the maximum deflection is 0.75 in, what is the modulus of elasticity for this beam?
Answers: 2
Another question on Engineering
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 18:10
Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.
Answers: 1
Engineering, 04.07.2019 18:20
Inadequate stores control is not an obstacle to effective work order system. (clo4) a)-true b)-false
Answers: 3
Engineering, 04.07.2019 18:20
Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent
Answers: 2
You know the right answer?
A load of 175 lbs is applied to a beam having a moment of inertia of 13.65 in^4, with the length of...
Questions
Mathematics, 04.03.2021 04:50
Mathematics, 04.03.2021 04:50
English, 04.03.2021 04:50
Social Studies, 04.03.2021 04:50
Mathematics, 04.03.2021 04:50
English, 04.03.2021 04:50
Mathematics, 04.03.2021 04:50
Mathematics, 04.03.2021 04:50
Mathematics, 04.03.2021 04:50
Mathematics, 04.03.2021 04:50
Mathematics, 04.03.2021 04:50
