subject
Engineering, 30.01.2021 01:00 Keo247

Which outcome most accurately portrays the future for the timber company in the following scenario? A timber company that cuts and sells its own wood has been in high demand for the past three years. The company has gone through many acres of forest in its area, but it is sure to plant tree seeds after it bulldozes a section.

The timber company will lose business soon because not many people will need to build houses and buildings anymore.
The timber company will run out of trees quickly because the seedlings will not have enough time to become full-grown timber.
The timber company will go out of business due to the rising number of buildings using cement and concrete rather than timber.
The timber company will continue to grow because of its good business practices, and it will become the number one timber company in the country.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
question
Engineering, 04.07.2019 18:10
Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2
Answers: 3
question
Engineering, 04.07.2019 18:10
Assuming compressible flow of air and that the measurements are done at flagstaff a pitot static tube that gives the difference of total and static pressure measures 0.35 m of mercury. what is the velocity of air? assume the temperature to be 300k. (submit your excel or matlab calculation sheet)
Answers: 1
question
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
You know the right answer?
Which outcome most accurately portrays the future for the timber company in the following scenario?...
Questions
question
Social Studies, 10.12.2020 20:20
question
Mathematics, 10.12.2020 20:20
question
Social Studies, 10.12.2020 20:20
question
Health, 10.12.2020 20:20
question
Mathematics, 10.12.2020 20:20
question
Mathematics, 10.12.2020 20:20
Questions on the website: 13722362