Engineering, 30.01.2021 14:00 robert7248

Task 3 - Prepare a PowerPoint for introducing 3D CAD modelling Your supervisor asked you to prepare a PowerPoint presentation to follow up the impact of
CAD system upgrade in company (from hand drawing to CAD) to the top management. Your
PowerPoint shall focus on evaluating the impact of the use of 2D and 3D CAD models on
final design requirements. Your evaluation must cover all the following three aspects
1. evaluate 2D and 3D drawings from a customer perspective. This links directly with
the P7 and M3 criteria.
2. compare and contrast the impact on customers of producing drawings using 2D and
3D CAD
3. predict how customers might use the information produced
The PowerPoint presentation file is limited to 15 pages

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines

Answers: 1

Answer

Engineering, 04.07.2019 18:10

An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Asteel wire of 2 mm diameter is fixed between two points located 2 m apart. the tensile force in the wire is 250n, if its density of steel is given by 7830 kg/m3 the fundamental frequency of vibration hz? ?

Answers: 3

Answer

You know the right answer?

Task 3 - Prepare a PowerPoint for introducing 3D CAD modelling Your supervisor asked you to prepare...

Questions