Engineering, 01.02.2021 21:00 Alexislol7908
A 1 cm diameter bar is 10 cm long. The first 4 cm are made of 2024-T6 aluminum, and the remainder of the bar is 304 SS. The free end of the aluminum is held at 550°C. The temperature at the interface between the materials is 540C. Determine how much heat is flowing through the bar, and what the temperature at the cold end is. Assume 1 dimensional heat transfer.
Answers: 1
Another question on Engineering
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
Engineering, 04.07.2019 18:10
Which of the following controllers anticipates the future from the slope of errors over time? a)-proportional b)-on/off c)-integral d)-derivative.
Answers: 2
Engineering, 04.07.2019 18:10
Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan
Answers: 3
Engineering, 04.07.2019 18:20
Have a greater impact on maintenance productivity than any other support group. (clo5) a)-the top management b)-inventory and purchasing c)-sub-contracting d)-cmms
Answers: 2
You know the right answer?
A 1 cm diameter bar is 10 cm long. The first 4 cm are made of 2024-T6 aluminum, and the remainder of...
Questions
Computers and Technology, 28.01.2020 22:41
History, 28.01.2020 22:42
Chemistry, 28.01.2020 22:42
Mathematics, 28.01.2020 22:42
