Engineering, 01.02.2021 23:00 trmcswain03

Let’s say I have two cylindrical segments of polymer that I’m testing in tension: The two materials are made of an identical substance, and the force applied to both is identical. In the undeformed state, the second cylinder has a cross-sectional area equal to half that of the first cylinder. Assume incompressible material with linear elasticity; no plastic deformation occurs.
A. How does the engineering (i. e. nominal) stress differ in the two samples?
B. How does the engineering (i. e. nominal) strain differ in the two samples?
C. How does the expected change in length differ in the two samples?
D. How does the true stress differ in the two samples?
E. How does the true strain differ in the two samples?

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:20

An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Asimple rankine cycle uses water as the working fluid. the water enters the turbine at 10 mpa and 480c while the condenser operates at 6 kpa. if the turbine has an isentropic efficiency of 80 percent while the pump has an isentropic efficiency of 70 percent determine the thermal efficiency

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Air flows over a heated plate àt a velocity of 50m/s. the local skin factor coefficient at a point on a plate is 0.004. estimate the local heat transfer coefficient at this point.the following property data for air are given: density = 0.88kg/m3 , viscosity 2.286 x 10 ^-5 kgm/s , k = 0.035w/mk ,cp = 1.001kj/kgk. use colburn reynolds analogy.

Answers: 1

Answer

Engineering, 04.07.2019 19:10

Agas contained within a piston-cylinder assembly e end nation about same energy states, 1 and 2, where pi 10 bar, v undergoes two processes, a and b, between the sam 0.1 m3, ui-400 kj and p2 1 bar, v2 1.0 m2, u2 200 kj: process a: process from 1 to 2 during which the pressure- volume relation is pv constant process b: constant-volume process from state 1 to a pressure of 2 bar, followed by a linear pressure-volume process to +20 0 state 2 kinetic and potential energy effects can be ignored. for each of the processes a and b, (a) sketch the process on p-v coordinates, (b) evaluate the work, in kj, and (c) evaluate process the heat transfer, in kj

Answers: 2

Answer

You know the right answer?

Let’s say I have two cylindrical segments of polymer that I’m testing in tension: The two materials...

Questions