subject
Engineering, 08.02.2021 19:10 jjgurl60

The undisturbed soil at a given borrow pit is found to have the following properties: w = 15%; γ= 5 19.1 kN/m^3 ; Gs = 2.70. The soil from this borrow is to be used to construct a rolled fill having a finished volume of 38,500 m3 . The soil is excavated by means of a shovel and dumped onto trucks having a capacity of 4.80 m^3 each. When loaded to capacity, these trucks are found to contain, on the average, a net weight of soil and water equal to 72.7 kN. In the construction process, the trucks dump their load on the fill and the material is spread and broken up, after which a sprinkler adds water until the moisture content is equal to 18%. The soil and water are thoroughly mixed by a disc (or similar equipment) and then compacted until the dry unit weight is equal to 17.3 kN/m^3.
a. Assuming that each load is a full capacity load, how many truckloads are required to construct the fill?
b. What should be the volume of the pit that remains in the borrow area, after all the material required for the fill has been removed?
c. How many liters of water will have to be added per truck load, assuming that the moisture lost by evaporation during excavation, haulage, and handling is negligible?
d. If the fill should become saturated at some time subsequent to the construction and does not change volume appreciably, what will be its water content at saturation?

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
question
Engineering, 04.07.2019 18:20
Find the kinematic pressure of 160kpa. for air, r-287 j/ kg k. and hair al viscosity of air at a temperature of 50°c and an absolute (10 points) (b) find the dynamic viscosity of air at 110 °c. sutherland constant for air is 111k
Answers: 3
question
Engineering, 04.07.2019 18:20
Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?
Answers: 2
question
Engineering, 04.07.2019 18:20
For a gate width of 2 m into the paper, determine the force required to hold the gate abc at its location.
Answers: 1
You know the right answer?
The undisturbed soil at a given borrow pit is found to have the following properties: w = 15%; γ= 5...
Questions
question
Mathematics, 16.04.2021 17:50
question
Mathematics, 16.04.2021 17:50
question
Mathematics, 16.04.2021 17:50
question
Mathematics, 16.04.2021 17:50
question
Arts, 16.04.2021 17:50
Questions on the website: 13722362