Engineering, 09.02.2021 22:10 liptontea4
2. A converging duct is supplied by a gas (R=2078 J/kg. K & γ = 1.3). Determine Mach number at one section of 10 cm2 area where the pressure and temperature are 100 kPa and 15 oC while gas flows at 300 m/s. Assuming one-dimensional isentropic flow, find Mach number, pressure, area and velocity at exit of the duct where the gas has a temperature of -10 oC.
Answers: 1
Another question on Engineering
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
Engineering, 04.07.2019 18:10
Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan
Answers: 3
Engineering, 04.07.2019 18:20
Inspection for bearing condition will include: (clo4) a)-color b)-smell c)-size d)-none of the above
Answers: 1
You know the right answer?
2. A converging duct is supplied by a gas (R=2078 J/kg. K & γ = 1.3). Determine Mach number at o...
Questions
Geography, 16.10.2020 20:01
Mathematics, 16.10.2020 20:01
Mathematics, 16.10.2020 20:01
Biology, 16.10.2020 20:01
History, 16.10.2020 20:01
Mathematics, 16.10.2020 20:01
Mathematics, 16.10.2020 20:01
Biology, 16.10.2020 20:01
