subject
Engineering, 11.02.2021 20:30 martl4175

Consider a hilly area in which new homes are being constructed. As rain falls on the site, without any controls, water running off the site would carry eroded soil particles to a nearby creek, polluting it badly. A detention pond is built to catch the particle-laden runoff at the bottom of the hill, to allow the soil particles to accumulate in the bottom of the pond while cleaner water overflows out of the pond and into the creek. For simplicity, assume that the rain is steady, all flows are steady, and ignore any transient effects on pond and water concentrations of soil particles. The water generated by the rain storm has a flow rate of 5.00 m3/min and entrains a concentration of particles of 4000. mg/L as it runs over the land. The nearby creek has a flow rate of 120. m3/min and normally carries an ambient concentration of 15.0 mg/L of soil particles. The detention pond will catch and remove most of the soil particles from the runoff, leaving outflow water (the water exiting the pond and flowing to the creek) with a concentration of 400. mg/L. Assume that 5% of the water that comes into the pond will seep down through the bottom (filtering out all particles), while the rest will over flow into the creek. a. Calculate the mass of mud accumulated in the detention ponds after three hours of this rainfall/runoff.
b. Calculate the concentration of particles in the creek after mixing with the overflow from the pond.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 03.07.2019 14:10
If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.
Answers: 3
question
Engineering, 03.07.2019 15:10
Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.
Answers: 1
question
Engineering, 04.07.2019 18:10
What difference(s) did you notice using a pneumatic circuit over hydraulic circuit.explain why the pneumatic piston stumbles when it hits an obstacle.
Answers: 2
question
Engineering, 04.07.2019 18:10
Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2
Answers: 3
You know the right answer?
Consider a hilly area in which new homes are being constructed. As rain falls on the site, without a...
Questions
question
Mathematics, 07.04.2020 18:27
question
Mathematics, 07.04.2020 18:27
Questions on the website: 13722362