subject
Engineering, 11.02.2021 21:10 SymiaF4980

A nuclear power station is situated in Coal Valley, which is a roughly rectangular valley that is 5 km long, 2 km wide, and 200 m deep. You have been asked to evaluate the effects of a worst- case scenario where the reactor housing fails, and radiation is released to the atmosphere. In your evaluation, you determine that 120 kg of lodine-131 (a radioisotope that causes thyroid gland and liver damage) could be released into the atmosphere. a. Assuming the release of lodine-131 was very rapid and all of it was uniformly distributed through the valley's atmosphere with none escaping the valley, what would the concentration of lodine-131 be in the valley's air? Your answer should be expressed in units of ppmv, and you may assume an atmopheric pressure of 1.0 atm and a temperature of 20°C.
b. Assuming the lodine-131 concentration you calculated in part (a) is the initial concentration in the valley, you now want to determine the time it will take for the concentration to decrease to the safe limit of 1.0% 10-5 ppmv. The average windspeed through the valley (entering at one end and exiting at the other) is only 1.5 m/min. However, lodine-131 also is removed by two other processes: 1) radioactive decay with a half life of 8.1 days, and 2) sedimentation to the ground with a rate constant of 0.02 d^-1. Draw a picture of the situation, and label the appropriate.
c. Now derive an equation that expresses the concentration of lodine-131 in the valley's air as a function of the time since the accident. Use the equation to determine the time needed for the concentration to decrease to a safe level.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Carbon dioxide gas expands isotherm a turbine from 1 mpa, 500 k at 200 kpa. assuming the ideal gas model and neglecting the kinetic and potential energies, determine the change in entropy, heat transfer and work for each kilogram of co2.
Answers: 2
question
Engineering, 04.07.2019 18:10
Journeyman training is usually related (clo2) a)-to specific tasks b)-to cost analysis of maintenance task c)-to control process to ensure quality d)-to installation of machinery
Answers: 2
question
Engineering, 04.07.2019 18:20
For each of the following process: a) sketch the p-v diagram, b)sketch t-s diagram, c) sketch t-v diagram, d) sketch the boundary work on one of the diagrams (a, b or c) and e) sketch the reversible heat transfer on one of the diagrams (a, b or c): 1- isobaric process from compressed liquid to superheated vapor 2- isothermal process from compressed liquid to superheated vapor 3- isentropic process from compressed liquid to superheated vapor
Answers: 3
question
Engineering, 04.07.2019 19:10
Ahelical coil spring has a mean diameter of 50 mm, a wire diameter of 5.5 mm and is wound with a pitch of 10 mm. the spring steel has an ultimate strength of 1250 mpa. find the force needed to compress the spring solid and the wire stress in this condition. state whether the spring will return to its initial length.
Answers: 1
You know the right answer?
A nuclear power station is situated in Coal Valley, which is a roughly rectangular valley that is 5...
Questions
question
Business, 16.09.2019 11:30
Questions on the website: 13722362