Engineering, 11.02.2021 21:20 DeathFightervx

Forced-convection heat transfer in flow between parallel plates (Fig. 10B.7). A viscous fl uid with temperature-independent physical properties is in fully developed laminar flow be- tween two flat surfaces placed a distance 2B apart. For 20 the fluid temperature is uniform at both walls. Find the temper- ature distribution T(x, z) for large z. (a) Make a shell energy balance to obtain the differential equation for Tx, 2). Then discard the viscous dissipation term and the axial heat conduction term. Steel plate 2500°F 100°F Fig. 10B.6. A composite furnace wall. Fig. 10B.7. Laminar, incom between parallel plates, both of whi. being heated by a uniform wall hea starting at z 0. mpressible v,(x) Direction of flow Fully developed slit flow at z-0; inlet temperature is T x =-B r-+B
(b) Recast the problem in terms of the dimensionless quantities kz (10B3
(c) Obtain the asymptotic solution for large z:

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Asimple rankine cycle uses water as the working fluid. the water enters the turbine at 10 mpa and 480c while the condenser operates at 6 kpa. if the turbine has an isentropic efficiency of 80 percent while the pump has an isentropic efficiency of 70 percent determine the thermal efficiency

Answers: 1

Answer

Engineering, 04.07.2019 19:10

Acircular aluminum shaft mounted in a journal is shown. the symmetric clearance gap between the shaft and journal is filled with sae 10w-30 oil at t 30°c. the shaft is caused to turn by the attached mass and cord. develop and solve a differential equation for the angular speed of the shaft as a function of time.

Answers: 2

Answer

You know the right answer?

Forced-convection heat transfer in flow between parallel plates (Fig. 10B.7). A viscous fl uid with...

Questions