subject
Engineering, 19.02.2021 16:30 leo4687

A Palm Spring golf course has requested a permit to install a 40000 ft2 pond to enhance the beauty of its facilities. Since the evaporation rates are very high in Palm Springs, it is likely they will need to pump a lot of groundwater to keep the pond full. The city has hired you (a water resources engineer) to determine how much water needs to be pumped per year in order to keep the pond filled. There is a small creek that discharges an average of 0.25 m3/s into the pond. The outlet valve from the pond releases an average rate of 0.30 m3/s (to keep the pond from getting stagnant). Precipitation on the pond is 260 mm/year, and the annual evaporation is estimated to be 105 inches/year. The pond will be lined with concrete to prevent any drainage or seepage 36 from the bottom. Required:
a. Using a water balance, what volume (on average) of groundwater (in cubic meters) must be added to the lake each year to keep the pond at a constant level?
b. Draw a schematic of the problem to identify the control volume and the relevant fluxes. Clearly write out/define your water balance equation and variables along with any assumptions you make.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.
Answers: 1
question
Engineering, 04.07.2019 18:10
Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.
Answers: 3
question
Engineering, 04.07.2019 18:10
Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented
Answers: 2
question
Engineering, 04.07.2019 18:10
Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.
Answers: 1
You know the right answer?
A Palm Spring golf course has requested a permit to install a 40000 ft2 pond to enhance the beauty o...
Questions
question
Physics, 21.07.2019 00:30
Questions on the website: 13722363