For a nozzle-duct system shown in Fig Q3, the nozzle is designed to produce a Mach number of 2.8 with y = 1.4, The inlet conditions are pos= 10 bar and T = 370 K. The duct is 8 diameters in length, but the duct friction factor is unknown. The receiver pressure is fixed at 3 bar and a normal shock has formed at the duct exit. (a) Determine the friction factor of the duct. (b) What is the total change in entropy for the system?​

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Determine whether or not it is possible to compress air adiabatically from k to 140 kpa and 400 k. what is the entropy change during this process?

Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.