Engineering, 22.02.2021 18:30 NNopeNNopeNNope

Help me, please! 1. How wide is the opening of the T-Slot?

2. What is the total length of the workpiece?

3. How many holes are tapped?

4. Determine dimension "A".

5. How thick is the workpiece?

6. How far apart horizontally are the two tapped holes on the left from the two counterbore holes on the left?

7. What is the minimum total depth of the T-Slot?

8. What is the maximum total depth of the T-Slot?

9. Determine dimension "B".

10. What size are the counterbores?

11. How far apart are the two counterbore holes on the left from the two counterbore holes on the right?

12. What is the upper limit dimension for the width at the bottom of the T-slot?

13. How far apart are the 3/8-16 tapped holes from the horizontal centerline of the workpiece?

14. Determine dimension "C".

15. How deep are the counterbores?

16. What is the distance between the two upper counterbore holes and the two lower tapped holes?

17. What is the lower limit dimension for the width at the bottom of the T-Slot?

18. What is the upper limit dimension on the width of the workpiece?

19. What sizes are the tapped holes?

20. What is the maximum thickness from the bottom of the T-Slot to the bottom of the workpiece?

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Apipe with an outside diameter of 15 cm is exposed to an ambient air and surrounding temperature of -20°c. the pipe has an outer surface temperature of 65°c and an emissivity of 0.85. if the rate of heat loss from the pipe surface is 0.95 kw per meter of length, the external convective heat transfer coefficient (h) is: (a) 12.5 w/m"k (b) 18.6 w/mk (c) 23.7 w/mk (d) 27.9 w/mk (e) 33.5 w/mk

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Vibration monitoring this technique uses the noise or vibration created by mechanical equipment and in seme cases by plant systems to detemine their actual condtion. a)- true b)- false

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent

Answers: 2

Answer

You know the right answer?

Help me, please! 1. How wide is the opening of the T-Slot?

2. What is the total length o...

Questions